Monitor® 17 Series Tub & Shower Trim with In2ition® in Chrome

Hi Shnayx2, Hi Shnayx2, thank you for contacting Delta Faucet Company! We apologize for the issues you are experiencing and are happy to help! Please gather a philips screwdriver and a strap wrench. Please note to shut off the water before removing any parts. 1. Please remove the temperature cap located on the tip of your handle by placing your fingers on the 'pointer' of the temperature cap and peeling upwards. This will be a little difficult as it is clipped into the temperature knob. 2. Once this piece is removed, you will see a plastic piece held in by a philips screwdriver. Please remove this part and be very careful not to drop the screw or the Rotational Limit Stop (looks like a black cog). Please note this black cog piece goes in one way. 3. Slide the sleeve assembly off of the valve. The sleeve is a decorative cylinder that covers the valve. 4. Place the strap wrench around the bonnet nut, and twist counterclockwise to remove it. 5. Remove the cartridge assembly inside the valve. You will now see a white plastic piece in your valve with seats and springs on each side. 6. Remove the white plastic piece with the seats and springs in it, and replace the new o-rings and seats and springs with the new ones. 7. We recommend flushing the valve before placing in new parts. Please refer to the instructions below. Flushing Shut the shower door or curtain and turn the water on to the valve. Water should gush out, much like an open fire hydrant. Have someone observe if there is good water pressure coming out of the valve and let it flush for 30 seconds. We appreciate your inquiry. Please reach out directly if you have further questions! Best Regards, Kyra Digital Communications Specialist

Hi SG22, Thanks so much for contacting Delta Faucet Company! The R10000-UNWSHF rough-in is for shower-only application as it does not feature a bottom port for a tub spout. For tub and shower installations we recommend the R10000-UNBX. Model R10000-UNWS is the same as the "UNBX" version except it features valve stops so you can turn the water off at the valve itself instead of the home's shut-off valve. Please reach out with further questions! Best Regards, Tim Digital Communications Specialist

Hi xmascurio, Thanks so much for contacting Delta Faucet Company about, T17435-I! The shower unit can be adjusted, I have attached a link to show how to adjust the RLS on our Delta shower cartridges. This will provide the option of hotter water, also, we recommend making sure the water heater temperature is set to 120 or lower. https://support.deltafaucet.com/s/article/How-do-I-set-the-adjustable-rotational-limit-stop-on-my-bath-or-shower-1628028366789 Please contact us directly if you have any questions or need additional assistance. Best Regards, Nicole Digital Communications Specialist

Hi kelly, Thank you for your question about the Delta Faucet model T17435-I. The included 2-in-1 shower head has a max flow rate of 1.75 gpm. The tub outlet has a max of 6.2 gpm. Please reach out with any additional questions! Best Regards, Bryan Digital Communications Specialist (800) 345-3358 customerservice@deltafaucet.com

Hi Rich T, thank you for contacting Delta Faucet Company! Yes, you can use the hand shower and shower head at the same time or only one at a time. We appreciate your inquiry. Please reach out directly if you have further questions! Best Regards, Kyra Digital Communications Specialist

Hi Donna, thank you for contacting Delta Faucet Company! Our T17235-I should be available by the end of Quarter 3 of 2022. We appreciate your inquiry. Please reach out directly if you have further questions! Best Regards, Kyra Digital Communications Specialist